Lotos Technology LTP8000 80 Amps Pliot Arc Plasma Cutter with Roller Guide

$1,981.22 (as of October 7, 2017, 10:32 pm)

80A plasma cutter.
200 to 240VAC, Dual Frequency (50Hz/60Hz).
Robust Infineon (By Siemens) IGBT Power Drive Matrix with Pilot arc Function integrated.

Buy product


Options. 80A plasma cutter.. 200 to 240VAC Twin Frequency 50Hz60Hz.. Powerful Infineon Via Siemens IGBT Energy Power Matrix with Pilot arc Serve as built-in.. Measurement – 28 x 18 x 14 in.Running Voltage. 208220vac 5060HZ Enter Single Segment.. 80amp Reduce attracts 41Amps.. 40amp Reduce attracts 20.5Amps.. 230V No Load Voltage.Slicing Specs. 1.50 in. Severance Reduce Most load With Lotos 80 Amps Torch.. 1 in. Perfect common Slicing.. 11 in. According to minute 1.25 in. Metal.. 15 in. According to minute 1 in. Thick Metal.. 17 in. According to minute .6 in. Thick Metal.. Prime Frequency and Contact Get started.. Prime Frequency DC Plasma cuts thicker fabrics than usual DC plasma cutters.. Energy Issue 0.93.. 100 Responsibility cycle at 40amp Reduce.. 60 Responsibility cycle at 80amp Reduce.. Air necessities 75psi 4.0cfm.. Twin Inside Prime Speed Cooling Lovers to Control Temperature and funky this unit.. LTP8000 has inbuilt Thermal Overload Coverage.Reduce at 12 Occasions the Speed of SoundPlasma Slicing is a procedure that may be used to chop Metal and different metals the use of a plasma torch. On this procedure an inert fuel compressed air is blown at Prime speed out of a nozzle; on the comparable time an electrical arc is shaped via that fuel from the nozzle to the outside that may be being Reduce turning a few of that fuel to plasma. The plasma is adequately hot to soften the steel being Reduce and actions sufficiently rapid to blow molten steel clear of the Reduce. The plasma that’s maintained among the paintings-piece and electrode travels at over 9000 MILES PER HOUR 15000 kmHandle. Thats over twelve Occasions the rate of sound.Benefit of Plasma vs. Oxy-Gas TorchPlasma does now not use pricey risky gases simplest compressed air. It imparts so much much less warmth into the piece being Reduce getting rid of warping. It does now not require ignition. It leaves little to no slag to scrub up or grind off. The fee According to Slicing hour can also be lower than oxy-Gas since there is not any fuel value. It is usually so much sooner and more straightforward. So you narrow higher sooner and inexpensively.
80A plasma cutter.
200 to 240VAC, Twin Frequency (50Hz/60Hz).
Powerful Infineon (Via Siemens) IGBT Energy Power Matrix with Pilot arc Serve as built-in.
Measurement – 28 x 18 x 14 in.Running Voltage
208/220vac 50/60HZ Enter Single Segment.

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.